Skip to main content

How to Troubleshoot an Email Forwarding Loop

An email forwarding loop occurs when an email is passed between two or more addresses in a continuous cycle, preventing it from reaching its final destination. This issue typically occurs in the Email system when multiple forwarding rules or filters...

An email forwarding loop occurs when an email is passed between two or more addresses in a continuous cycle, preventing it from reaching its final destination. This issue typically occurs in the Email system when multiple forwarding rules or filters conflict with one another.

Before you begin

You will need:

  • Access to your email account's webmail interface or management console.

  • Knowledge of the specific email addresses involved in the loop.

Identify the source of the loop

To resolve a forwarding loop, you must identify where the circular logic is being triggered.

  1. Identify the email addresses involved in the loop.

  2. Check the forwarding settings for each address involved.

  3. Check the filters and rules for each address involved.

  4. Look for "circular" logic, such as:

    • Address A forwards to Address B.

    • Address B forwards to Address A.

    • Address A forwards to Address B, which then forwards to a third address that redirects back to Address A.

Resolve the conflicting rules

Once you identify the conflicting rules, you must disable or correct them.

  1. Log into the webmail interface for the primary account.

  2. Navigate to the Mail Settings or Forwarding section.

  3. Disable any forwarding rules that point to an address that also forwards back to the original account.

  4. Navigate to the Filters or Rules section.

  5. Delete or modify any rules that create a loop between two different email accounts.

Note: If you are using a third-party service to manage your mail (such as a CRM or a secondary mail processor), ensure that the rules within that external service do not conflict with your primary Hostek email settings.

Confirm the result

After removing the conflicting rules, you can verify the fix by sending a test email.

  • Send a test email to the primary address.

  • Confirm the email arrives at the intended destination without being "bounced" or getting stuck in a loop.

  • Check the "Sent" or "Outbox" folder of both accounts to ensure the message is no longer being processed multiple times.

Limitations

This procedure addresses loops caused by internal configuration. If a loop is caused by a third-party application or an external mail server's configuration, you may need to contact that specific provider to adjust their routing rules.

Did this answer your question?