Skip to main content

How to Allow an IP Address to Open the ColdFusion Administrator

This article explains how to configure the Windows Control Panel (WCP) to allow a specific IP address to access the ColdFusion Administrator. This task is performed by a Server Administrator and is required when the ColdFusion Administrator is...

This article explains how to configure the Windows Control Panel (WCP) to allow a specific IP address to access the ColdFusion Administrator. This task is performed by a Server Administrator and is required when the ColdFusion Administrator is restricted by a firewall or security policy.

Important: This feature is only available on Hostek plans that include ColdFusion or Lucee.

Before you begin

You will need:

  • Server Administrator access to the Windows Control Panel (WCP)

  • The specific IP address of the device or network that requires access

  • Access to the ColdFusion or Lucee management interface

Allow an IP Address to Open the ColdFusion Administrator

  1. Log in to the Windows Control Panel (WCP).

  2. Navigate to ColdFusion > ColdFusion Administrator.

  3. Locate the Allow IP Addresses section.

  4. Enter the IP address or range of allowed addresses. Use the format 192.0.2.10 for a single IP or 192.0.2.0/24 for a subnet.

  5. Select Save or Apply to update the configuration.

Confirm the result

  • The ColdFusion Administrator will now be accessible from the specified IP address.

  • The configuration will be reflected in the WCP interface under the ColdFusion settings.

Limitations

This procedure only manages the access permissions within the Windows Control Panel environment. If the IP address is still blocked, the issue may be caused by a hardware firewall, a local network firewall, or a Windows Firewall rule that has not been updated to include the new IP.

Did this answer your question?