Verify that your SmarterMail server is not configured as an open relay to ensure that only authorized users can send email through your system. This procedure is performed by a System Administrator to maintain security and prevent your server from being used to send unauthorized or spam content.
Before you begin
You will need:
System Administrator access to the SmarterMail management interface.
Access to an external email testing tool or a secondary email account outside of your organization.
Verify relay status via the SmarterMail interface
SmarterMail includes built-in protections to prevent unauthorized relaying. You can verify these settings within the administration panel.
Log in to the SmarterMail administration interface.
Navigate to Settings > Mail Settings.
Review the SMTP Authentication settings.
Ensure that the system is configured to require authentication for outgoing mail unless specifically exempted for a trusted IP range.
Verify relay status via external testing
To confirm that the server is not accepting mail from unauthorized sources, perform a manual test using an external mailer or a command-line tool.
Use an external tool (such as a web-based SMTP tester) or a command-line tool like
telnetornc(netcat) to connect to your mail server's SMTP port (typically 25, 465, or 587).Attempt to send an email from a source that does not have valid credentials for your SmarterMail system.
Observe the server's response.
Note: If the server is correctly configured, it should reject the connection or the "RCPT TO" command with an error message indicating that authentication is required.
Confirm the result
The verification is successful if:
The SmarterMail interface shows that authentication is required for outgoing mail.
An external attempt to send mail without credentials results in a "Relay Access Denied" or "Authentication Required" error from the server.
If you receive a "Relay Access Denied" error from an authorized user
If a legitimate user is unable to send mail and receives a "Relay Access Denied" error, the issue is likely with their specific account configuration or the local mail client settings.
Verify the user's credentials in the SmarterMail administration panel.
Ensure the user's mail client is configured to use "Authentication" for the outgoing server.
Check if the user's IP address is within a range that has been explicitly allowed for relaying in the SmarterMail settings.
Limitations
This procedure confirms that the SmarterMail software is not configured as an open relay. It does not account for potential misconfigurations in external firewalls or third-party mail gateways that may be positioned in front of the SmarterMail server.
